Masonry Drill Bits And Ceramic Tile

It doesn't matter if drilling into ceramic tile is something that you will only need to do one time or on a regular basis, masonry drill bits might be a tool that you will need to own. While there are some other options available, such as an annular cutter, your best bet always comes from being prepared with any tools you may need for a project. There are several issues that you may encounter while working with ceramic. To give you a better idea about what kinds of tools you may need, here is a quick look at some of the most common problems and why they exist.

There are two primary problems that people will run into when dealing with ceramic tile. The first is that during the drilling process they will shatter the tile. Tiles don't often just crack. They either make it through the process without a problem or they shatter. Another common problem is that the drill bit will start to smoke because of the friction that it creates. In fact, sometimes your drill bit can turn bright, cherry red. In order to handle the obstacles that go hand in hand with ceramic, most people turn to either masonry drill bits or an annular cutter.

It is important to remember that ceramic tiles are artificial. You cannot find "ceramic" in the natural environment. However, just like the natural environment, some ceramic is denser and tougher than others. For example, real porcelain can be incredibly difficult to work with. Porcelain is hard to deal with for a few different reasons. The first is that it has a much higher silica content than regular clay-based tile. Additionally, it is normally fired in a kiln at a much higher temperature, for a much longer amount of time. Finally, the high silica content will make cutting it with a snapper tile cutter nearly impossible because it cannot withstand the pressure. This is why masonry drill bits are essential to the success of working with ceramic.

The key to dealing with tile all lies within the first few centimeters. Most ceramic tiles are made out of clay with a thin silica glaze. Once you get through the silica, getting through the rest of the clay is a snap. The carbide tip is what makes masonry drill bits so much more effective. When using masonry bits on silica it is important to start off at very low drill speeds, otherwise you will shatter it. By using a drill that spins too fast or by applying too much pressure, you can end up without a hole..as well as some ugly scratches.

For the most part, masonry drill bits should be considered essential for anyone who will be working with ceramic tile. It doesn't matter if it is all porcelain or clay with a silica glaze. However, if you find yourself in a situation where you need to drill larger holes than you have bits for, then consider using a diamond tip annular cutter. This will allow you to create a larger hole, without shattering the tile.


------

For more information on masonry drill bits and annular cutter, visit hermanscentral.com